Analysis of Torques in Single-Side Linear Induction Motor With Transverse Asymmetry for Linear Metro

作者：Lv, Gang^*; Liu, Zhiming^*; Sun, Shouguang^*

来源：IEEE Transactions on Energy Conversion, 2016, 31(1): 165-173.

DOI：10.1109/TEC.2015.2470561

• Edge effects
• horizontal torque
• linear induction motor
• longitudinal end effects
• normal torque
• side torque
• three-dimensional analysis
• thrust
• vertical force

Due to the magnetic distortion and nonuniform force density of the single-side linear induction motor (SLIM) caused by the lateral movement, edge, and end effects, three types of torques, i.e., the side, normal, and horizontal torques, are produced. This paper investigates these special torques of the SLIM for metro and the variations of these torques when the primary is displaced sideways from a symmetrical position. It is of prime importance to take longitudinal end effects, edge effects, overhang of the primary windings, and lateral displacement into consideration when the air-gap flux density distributions and special torques are calculated via a 3-D analytical method. The air-gap flux density distributions along longitudinal and transverse directions, as well as the force density and torques with the different lateral displacements, are comprehensively investigated when the motor works in the motoring operation. The analytical results are experimentally validated by measurements on a reciprocal power-fed test rig. It shows that the horizontal and side torques, which increase the instability of the suspension system and the antirolling bar of bogie, increase almost linearly with the increase of the lateral displacement. Normal torque decreases with the increasing lateral displacement.

• 出版日期2016-3
• 单位北京交通大学