Size Effects in Thin Face-Centered Cubic Metals for Different Complex Forming Loadings

作者：Dubos Pierre Antoine^*; Hug Eric; Thibault Simon; Ben Bettaieb Mohamed; Keller Clement

来源：Metallurgical and Materials Transactions A-Physical Metallurgy and Materials Science, 2013, 44A(12): 5478-5487.

DOI：10.1007/s11661-013-1892-7

Influence of the size effects on the mechanical behavior of face-centered cubic metals was studied for complex loadings close to microforming ones. The effect of a reduction in thickness (t) over grain size (d) ratio on the mechanical behavior for high-purity nickel and copper is investigated for three different loadings by tensile and Nakazima tests (plane strain conditions and balanced biaxial expansion). Experimental results highlight a strong degradation of the mechanical properties of Cu and Ni when the t/d ratio is reduced below a critical value, independently of the strain path. However, this effect occurs if the equivalent plastic strain is larger than a critical level which is strain path dependent and related to the stress triaxiality. The current study reveals that plastic anisotropy is also affected by size effects. An excellent correlation is obtained between the t/d ratio and the thickness reduction, through the mean normal plastic anisotropy parameter which is widely used to estimate sheet formability. A size effect map based on forming limit diagrams is proposed to depict the optimal conditions of microforming.

• 出版日期2013-12