Deep micro-hole drilling of Hardox 500 by electro-discharge machining

作者：Yilmaz Volkan^*

来源：Materialprufung, 2016, 58(1): 69-74.

DOI：10.3139/120.110821

• Electro discharge machining
• Hardox 500 material
• micro drilling
• deep hole drilling
• fast hole drilling

In this study, micro-size drillability of Hardox 500 was investigated by the electro-discharge machining (EDM) method. For this purpose, holes were drilled by using different machining parameters (discharge current, electrode rotational speed, dielectric spray pressure) and the effect of these parameters on machining performance and hole profile was specified. At the end of the tests, it was detected that discharge current and electrode rotational speed increased material removal rate (MRR), electrode wear rate (EWR) and hole dimensional error (DE) whereas dielectric spray pressure increased the MRR values and decreased the EWR and DE values.

• 出版日期2016-1