Measurement method and influencing factors of temperature and humidity of condensed flue gas based on in situ flue gas heat tracing

作者：Gao, Jianmin^*; Sun, Zhihao; Wang, Zhiqiang; Wang, Xin; Guan, Jian; Qi, Guoli; Wang, Zhongwei; Du, Qian; Qin, Yukun

来源：Measurement, 2018, 120: 100-106.

DOI：10.1016/j.measurement.2018.01.067

• Condensing boiler
• Flue gas
• Condensation
• Supercooling
• Thermal test
• Interlayer pumping

Condensing boilers are efficient for the utilization of natural gas. However, condensed droplets in flue gas are supercooled after condensation heat transfer, and direct contact devices cannot accurately measure the temperature of flue gas containing such droplets. Therefore, an in situ heating interlayer pumping device was designed. Experimental results showed that in situ heating interlayer pumping device can effectively filtered out the influence of supercooled droplets, the temperature of flue gas measured by the proposed device was about 3 degrees C higher than that measured by direct contact temperature measuring device; the device optimum flow rate was 0.35 L/min, optimum heat tracing temperature was in the range 100-140 degrees C; the effective reliability of the device was verified experimentally using the positive balance efficiency and the counter balance efficiency of 30-kW gas-fired condensing heat-transfer test platform.

• 出版日期2018-5
• 单位哈尔滨工业大学; 中国特种设备检测研究院; 煤炭科学技术研究院有限公司