Built-up edge investigation in vibration drilling of Al2024-T6

作者：Barani A; Amini S^*; Paktinat H; Tehrani A Fadaei

来源：Ultrasonics, 2014, 54(5): 1300-1310.

DOI：10.1016/j.ultras.2014.01.003

• Vibration drilling
• Drilling
• Ultrasonic
• Aluminum 2024-T6

Adding ultrasonic vibrations to drilling process results in an advanced hybrid machining process, entitled %26quot;vibration drilling%26apos;%26apos;. This study presents the design and fabrication of a vibration drilling tool by which both rotary and vibrating motions are applied to drill simultaneously. High frequency and low amplitude vibrations were generated by an ultrasonic transducer with frequency of 19.65 kHz. Ultrasonic transducer was controlled by a MPI ultrasonic generator with 3 kW power. The drilling tool and workpiece material were HSS two-flute twist drill and Al2024-T6, respectively. The aim of this study was investigating on the effect of ultrasonic vibrations on built-up edge, surface quality, chip morphology and wear mechanisms of drill edges. Therefore, these factors were studied in both vibration and ordinary drilling. Based on the achieved results, vibration drilling offers less built-up edge and better surface quality compared to ordinary drilling.

• 出版日期2014-7