An Input-Feedforward Multibit Adder-Less Delta-Sigma Modulator for Ultrasound Imaging Systems

作者：Jung Youngjae^*; Roh Hyungdong; Roh Jeongjin

来源：IEEE Transactions on Instrumentation and Measurement, 2013, 62(8): 2215-2227.

DOI：10.1109/TIM.2013.2253911

• Analog-to-digital converter
• delta-sigma modulator
• input-feedforward architecture
• switched-capacitor circuit
• ultrasound imaging system

This paper describes a high-speed delta-sigma modulator with 65-nm CMOS technology for ultrasound imaging systems. The delta-sigma modulator is based on a 4th-order single-loop switched-capacitor architecture with a 4-bit quantizer. The designed modulator has the advantages associated with input-feedforward architecture, such as the reduced output swing of the integrator, which relaxes the amplifiers%26apos; design requirements. Due to the power and area overheads and the timing constraint of the active adder in the conventional multibit input-feedforward modulator, we use an adder-less input-feedforward delta-sigma architecture. As a result, the designed architecture eliminates the extra power consumption and silicon area required by the adder. The designed architecture also relaxes the timing requirement for the quantizer and the dynamic element-matching block compared with the conventional delta-sigma modulator. The modulator achieves a dynamic range of 76 dB and a peak signal-to-noise-plus-distortion ratio of 72.3 dB in a signal bandwidth of 6 MHz. The power consumption is 18.5 mW with 1.2-V supply voltage, and the chip core size is 0.25 mm(2). The energy required per conversion step is 0.46 pJ/conv.

• 出版日期2013-8