科研之友
微信
新浪微博
Facebook
分享链接
摘要
Hydrogen and syngas production have been investigated from the pyrolysis/gasification of biomass components (cellulose, xylan and lignin) in the presence of Ni-based catalysts by using a two-stage fixed-bed reaction system. Biomass samples were pyrolysed at the first stage and the derived products were gasified at the second stage. The Ni-Mg-Al and Ni-Ca-Al catalysts, prepared by co-precipitation, were applied in the gasification process. The lignin sample pyrolysed with more difficulty (56.0 wt.% of residue fraction) compared with cellulose and xylan at 500 degrees C, and therefore resulted in the lowest gas yield (42.7 wt.%) for the pyrolysis/gasification of lignin. However, the highest H-2 concentration from the three types of feedstock (55.1 vol.%) was collected for the lignin sample in the presence of steam and catalyst. Carbon deposition was very low as indicated from the TPO and SEM analyses of the reacted Ni-Mg-Al catalyst. The investigation of reaction conditions showed that water injection rate (0.02 and 0.05 g min(-1)) had little influence on the gas production from the pyrolysis/gasification of lignin in the presence of the Ni-Ca-Al catalyst; however, the increase of gasification temperature from 700 to 900 degrees C resulted in a higher gas and hydrogen production due to the promotion of secondary reactions during the gasification process. Furthermore, coking was highest for the reacted Ni-Ca-Al catalyst at the gasification temperature of 800 degrees C (7.27 wt.%), when the temperature was increased from 700 to 900 degrees C. This work shows that the components of biomass have a significant influence on the catalytic gasification process related to hydrogen and syngas production.
- 出版日期2013-1
