Analysis of Vertical Marginal Adaptation of Zirconia Fixed Dental Prosthesis Frameworks Fabricated by the CAD/CAM System: A Randomized, Double-Blind Study

作者：Mello Caroline; Santiago Junior Joel Ferraro; Galhano Graziela; Quinelli Mazaro Jose Vitor; Scotti Roberto; Pellizzer Eduardo^*

来源：International Journal of Prosthodontics, 2016, 29(2): 157-160.

DOI：10.11607/ijp.4285

Purpose: The purpose of this study was to evaluate the marginal adaptation of fixed dental prosthesis frameworks fabricated by computer-aided design/computer-assisted manufacture (CAD/CAM) with three different systems of data acquisition. Materials and Methods: A total of 50 specimens were fabricated as follows: using the conventional method (Ni-Cr) (n = 10); iTero/industrial milling (Group 1, n = 10); Cerec Bluecam/industrial milling (Group 2, n = 10); 3S/industrial milling (Group 3, n = 10); and Cerec BlueCam/Sirona milling (Group 4, n = 10). The specimens were numbered and randomized, and the vertical marginal discrepancy was analyzed. Results: Intraobserver analysis indicated no statistically significant difference (paired t test, P = .822) between periods before and after analysis. The conventional method (321 mu m) showed greater discrepancy when compared with the CAD/CAM system (89 mu m) (P < .001). The intraoral system showed a lower rate of marginal discrepancy when compared with the extraoral system (3S) (P < .001). The closed system presented a higher marginal discrepancy (114 mu m) than the open intraoral system (iTero) at P < .001. In addition, the intraoral system when open showed statistically significant differences in mean marginal discrepancy values compared with the same system in closed condition (P > .05). Conclusion: The CAD/CAM systems showed less marginal discrepancy than the conventional method for the fabrication of the frameworks.

• 出版日期2016-4