An output node split CMOS logic for high-performance and large capacitive-load driving scenarios

作者：Rafiee M; Ghaznavi Ghoushchi M B^*

来源：MICROELECTRONICS JOURNAL, 2018, 72: 109-119.

DOI：10.1016/j.mejo.2017.12.010

• High-performance
• Large capacitive-load driver
• Tune power and performance
• Split output node

In this paper, a new logic with split pull-up (PUN) and pull-down (PDN) networks of static CMOS is presented. The isolation is performed through a push-pull stage and an inner-feedback-interface. This causes two separated outputs of PUN/PDN to have the same voltage in identical evaluating points. Therefore, delay of proposed logic is less than CMOS. Maximum allowable load capacitance of proposed logic is increased. Adaptive-Body-Biasing (ABB) is used during the run-time to change the transistor's effective-threshold-voltage in tradeoff for power and delay. To show the effectiveness of the new logic, an 8-bit Ripple-Carry Adder (RCA), an 8-bit Wallace multiplier and a 16-bit Carry-Look-Ahead Adder (CLA) are implemented and evaluated against, pseudo-static [1] and static CMOS logics on 65 nm standard CMOS technology. Simulations show that proposed logic is 15 and 35% faster than CMOS and pseudo-static, respectively. The proposed logic comes with 28% speedup over CMOS in low-voltage region due to fewer series stages between supply voltage and ground nodes.

• 出版日期2018-2