An ionic liquid doped electrochemical copolymer coating of indole and 3-methylthiophene for the solid-phase microextraction of polycyclic aromatic hydrocarbons

作者：Guo, Xiafei; Mulati, Aiziguli; Wu, Mian; Zhang, Jie; Yang, Liu; Zhao, Faqiong; Zeng, Baizhao^*

来源：RSC Advances, 2017, 7(36): 22256-22262.

DOI：10.1039/c7ra02372c

• STAINLESS-STEEL WIRE
• GAS-CHROMATOGRAPHY
• MASS-SPECTROMETRY
• POLYPYRROLE FILMS
• HEADSPACE
• FIBER
• COMPOSITE
• DERIVATIVES
• EXTRACTION
• ENRICHMENT

A novel poly(indole-co-3-methylthiophene)-ionic liquid (i. e., 1-allyl-3-vinylimidazolium bis((trifluoromethyl)sulfonyl)imide) (P(In-3-MeT)/IL) composite film was electrodeposited on a stainless steel wire for headspace solid phase microextraction. The obtained P(In-3-MeT)/IL coating was rough and showed a cauliflower-shape. It had high thermal stability (up to 450 degrees C) and mechanical stability and could be used for at least 180 times in solid phase microextraction (SPME) without a decrease in extraction performance. The coating exhibited high extraction capacity for some polycyclic aromatic hydrocarbons (e. g. naphthalene, 1-methylnaphthalene, acenaphthene, biphenyl, fluorene and phenanthrene) due to the strong hydrophobic and pi-pi interactions between the analytes and P(In-3MeT)/IL. Through coupling with GC, good linearity (correlation coefficients higher than 0.9994), wide linear ranges (0.05-50 mu g L-1) and low limits of detection (6.25- 25.2 ng L-1) were achieved for these analytes. The reproducibility (defined as RSD) was 3.5-5.5% and 4.5-7.2% for single fiber (n = 5) and fiber-to-fiber (n = 5), respectively. The SPME-GC method was successfully applied for the determination of three real samples, and the recoveries for standards added were 86.8-105% for mosquito-repellent incense, 89.9-110% for cigarettes and 82.3-103% for industrial lubricant.

• 出版日期2017
• 单位武汉大学