Process and performance evaluation of ultrasonic, induction and resistance welding of advanced thermoplastic composites

作者：Villegas Irene Fernandez^*; Moser Lars; Yousefpour Ali; Mitschang Peter; Bersee Harald E N

来源：Journal of Thermoplastic Composite Materials, 2013, 26(8): 1007-1024.

DOI：10.1177/0892705712456031

• Thermoplastic composites
• resistance welding
• induction welding
• ultrasonic welding
• mechanical properties

The possibility of assembling through welding is one of the major features of thermoplastic composites and it positively contributes to their cost-effectiveness in manufacturing. This article presents a comparative evaluation of ultrasonic, induction and resistance welding of individual carbon fibre-reinforced polyphenylene sulphide (PPS) thermoplastic composite samples that comprises an analysis of the static and dynamic mechanical behaviour of the joints as well as of the main process variables. The induction welding process as used in this research benefitted from the conductive nature of the reinforcing fibres. Hence, no susceptor was placed at the welding interface. Resistance welding used a fine-woven stainless-steel mesh as the heating element and low welding pressures and times were applied to prevent current leakage. Triangular energy directors moulded on a separate tape of PPS resin were used to concentrate ultrasonic heat at the welding interface. The static single-lap shear strength of the joints was found similar for induction and ultrasonic welding. A 15% drop in the static mechanical properties of the resistance welded joints was attributed to incomplete welded overlaps following current leakage prevention. However, the fatigue performance relative to the static one was similar for the three sorts of joints. A comparative analysis of process variables such as welding time, required power and energy was also carried out.

• 出版日期2013-9