Determination of the impact tensile strength of structural adhesive butt joints with a modified split Hopkinson pressure bar

作者：Yokoyama Takashi^*; Nakai Kenji

来源：International Journal of Adhesion and Adhesives, 2015, 56: 13-23.

DOI：10.1016/j.ijadhadh.2014.07.011

• Epoxy
• Al alloy, pure titanium
• Butt joint, finite element stress analysis
• Impact

The impact tensile strength of structural adhesive butt joints was determined with a modified split Hopkinson pressure bar using hat-shaped specimens. A typical two-part structural epoxy adhesive (Scotch weld (R) DP-460) and two different adherend materials (Al alloy 7075-T6 and commercially pure titanium) were used in the adhesion tests. The impact tensile strength of adhesive butt joints with similar adherends was evaluated from the peak value of the applied tensile stress history. The corresponding static tensile strengths were measured on an Instron testing machine using joint specimens of the same geometry as those used in the impact tests. An axisymmetric finite element analysis was performed to investigate the static elastic stress distributions in the adhesive layer of the joint specimens. The effects of loading rate, adherend material and adhesive thickness on the joint tensile strength were examined. The joint tensile strength was clearly observed to increase with the loading rate up to an order of 10(6) MPa/s, and decrease gradually with the adhesive thickness up to nearly 180 mu m, depending on the adherend materials used. The loading rate dependence of the tensile strength was herein discussed in terms of the dominant failure modes in the joint specimens after static and impact testing.

• 出版日期2015-1